Chevy inline 4 cylinder for my IMP

[Robert Brown]

Does anyone out there Know of a parts house where I can purchase an intake and exhaust manifold or steel tube header for an 1983 through 1985 Chevy in line 4 cylindar.
Also have for sale Ford V4 Complete engine bell housing clutch and 3 speed standard Tranny runs great
I am pulling out the V4 and going with the Chevy in line 4 with an automatic transmision.

 

[Snowtrac Nome]

Does anyone out there Know of a parts house where I can purchase an intake and exhaust manifold or steel tube header for an 1983 through 1985 Chevy in line 4 cylindar.
Also have for sale Ford V4 Complete engine bell housing clutch and 3 speed standard Tranny runs great
I am pulling out the V4 and going with the Chevy in line 4 with an automatic transmision.

i would go to gm and pick up a intake and exhaust header for the tbi 400 model i have one compleate with tbi unit wiring harness and computer i plan to put into something some day. the tbi models came with a factory shortie header and produced better fuel economy and preformance than there carbed brothers and gm tbi is unsurpassed for reliability and simpicity even a amiture could wire up one in a weekend

 

[fogtender]

If you are going to do the engine switch, you might concider putting a thre or fou cylinder diesel in there instead. More low end power and you will get double or better the range. You can still mate up an auto trans, but pull the entire setup out of a smaller car/truck with the diesel package already.

Having had the imp with the gas, had I kept it, I was concidering doing that. You can also installed a diesel fired heater to preheat and heat the cab without running the engine.

 

[mwolfca]

If you still have it how much for the V-4? I have a 72 that had a worn out balance shaft gear I replaced the gear but has just not run right since.