No. 227 was one of 18 yellowstone-type locomotives built by the Baldwin Locomotive Works for the Missabe Road during World War II, years 1941 and 1943. It was built in 1941, and named after the Frenchman who designed it- Mallet (pronounced Mally). Diesel engines were making an appearance around this time period, but were a relatively unknown entity. Since cost and logistics of fuel and maintenance supplies were not paramount on the design constraints list, the decision was made to stay with a coal burning steam locomotive. During its 20-year operating life, shortened by dieselization, the No. 227 hauled approximately 40 million long tons of iron ore from the mines on the Mesabi and Vermillion Ranges to the docks at Duluth and Two Harbors. Steam locomotives were rather expensive to operate, and the later proven diesel locomotives were a natural replacement, so the No. 227 was retired in 1960.
Weighing some 566 tons in working order, and stretching 128 feet in length, the No. 227 is one of the largest and most powerful steam locomotives ever constructed. Capable of developing 6,000 drawbar horsepower, it made routine work of handling 180-190 car trains weighing more than 18,000 tons. As a contrast, No. 227 had a pulling power of 30 times that of the WILLIAM CROOKS.
The engine was designed to operate efficiently at 45 miles per hour. When working at full power, it could consume some 10 to 12 tons of coal an hour and evaporate water into steam at the astounding rate of 12,000 gallons per hour. The amount of coal the engine used in one hour would be enough to heat a home for two winters. It carried 26 tons of coal and 25,000 gallons of water in its tender.
The No. 227 is an articulated locomotive, meaning there are two engines, which are hinged together beneath a single boiler. The articulated evolved because engines with four, five, or six coupled axles became more and more difficult to build and maneuver. By hinging the driving wheels in two sets, a much larger and more powerful locomotive could be built that could travel easier through curves. The boiler was attached to the rear engine, enabling the front engine to pivot freely from side to side. The boiler rests on a sliding plate, which transfers part of the weight to the front engine. Due to the lateral wanderings of the front engine, the boiler would swing far to the outside of curves.
No. 227 was restored for the Museum through the efforts of the DM&IR Veteran Employees Association, which contributed in excess of $8,000 toward the project. The DM&IR matched that contribution, performed all restoration, and donated the locomotive to the Museum.
6000 draw bar horsepower and it articulated. But what I was looking for and now I can't find it was I thought I read an article on this rig that it was actually converted to kerosene. But now I can't find that any more. I will have to look at home to see if I can find where I read that.
murph