Well today I got the carb cleaned and did a tuneup, got the exhaust sealed up(blown gasket). I also started cutting floor panels, I am waiting for the raptor liner to show up so it was about all I could do. I cut them out of 1/2 plywood, and hope to start cutting the back and side panels tomorrow. Back and sides will also be out of 1/2 inch and then upper panels will be underlayment or 1/4 inch.
Passenger side with sealer on it.
Just set in place they will be sprayed with raptor liner.
Passenger side in place
Rear seat area
I will be pulling the panels back out and spraying all aluminum floor and sides with raptor liner. THe plywood will also be sprayed with raptor liner. I will then put a rubber mat on top to finish off.
Anyone got a line on flat rubber flooring with a jute insulation on the back? I have searched high and low and cant find anything but I know its out there.