My son was bringing firewood up to the house last night. Got his sweatshirt caught in the ATV throttle while getting off. The ATV took off, sideswiped the house and sheared off the outside water spigot.
There's not enough pipe sticking out to solder or attach a sharkbite around the outside of the pipe.
Looking for ideas/options for connecting a new spigot but need to go inside the existing pipe unless I start tearing out mortar.
Not sure how well I could do a sweat joint since it's embedded in the brick so ideally, I'd like to find a self-tapping or compression fit connector that would go inside the existing pipe.
I checked SharkBite connectors site and I don't see they make something like this.
Ideas?
There's not enough pipe sticking out to solder or attach a sharkbite around the outside of the pipe.
Looking for ideas/options for connecting a new spigot but need to go inside the existing pipe unless I start tearing out mortar.
Not sure how well I could do a sweat joint since it's embedded in the brick so ideally, I'd like to find a self-tapping or compression fit connector that would go inside the existing pipe.
I checked SharkBite connectors site and I don't see they make something like this.
Ideas?