kgracey
New member
Hey everybody,
Now that we have pulled the blown Allis Chalmers and found a replacement we're looking into what else we need to replace inside of this machine. It looks like the gear and spline in the Marco Hydraulic Pumpo Drive splitter box is very worn. We need to replace both the male/female sides.
The splitter box has the part number DP26-2-11-1.1E-C4. The female side of the spline has the part number GTW Seattle K74081.
Where can I find these two spline parts that connect the splitter to the engine? Any suggestions are most appreciated at this stage since we'll do nearly anything to save some time over the next week of work while we install a new AC engine.
Thanks!
Now that we have pulled the blown Allis Chalmers and found a replacement we're looking into what else we need to replace inside of this machine. It looks like the gear and spline in the Marco Hydraulic Pumpo Drive splitter box is very worn. We need to replace both the male/female sides.
The splitter box has the part number DP26-2-11-1.1E-C4. The female side of the spline has the part number GTW Seattle K74081.
Where can I find these two spline parts that connect the splitter to the engine? Any suggestions are most appreciated at this stage since we'll do nearly anything to save some time over the next week of work while we install a new AC engine.
Thanks!