While back I purchased two new gas transfer pumps, one manual rotary type and one 12V electric. In order to gas out of the manual, I have to prime it with a squirt of oil. (I drilled a 1/4' hole at the output elbow, which is plugged with a screw when pumping starts).
My question is: is this normal or the pump is screwup. Is there something I can do other than using my inconvenient method?
The pump is mounted in a 55 gal. drum.
The electric pump just quit pumping after few times. It runs, just it is not getting the gas out. I have not done inside exploration yet. I like to get some suggestions before I do it .
My question is: is this normal or the pump is screwup. Is there something I can do other than using my inconvenient method?
The pump is mounted in a 55 gal. drum.
The electric pump just quit pumping after few times. It runs, just it is not getting the gas out. I have not done inside exploration yet. I like to get some suggestions before I do it .