Hello glad I found this forum. I am a sort of new chainsaw user. been 15 years since my last saw. Just a Home user not pro. A few weeks ago I purchased me a Husky 240 16" chainsaw for fathers day Great little saw. Use will be for blow downs ,suckers wat to open some of my 2 + acres up open up , not the full 2 acres just clean up..
Issue first 5/6 tanks ran flawless. I run a tank then take a break, went to cut some more about 1 hr later, saw would not idle. throttle all ok no burps or farts. Drop off to my dealer, they adjusted idle. all good for 1 tank. then started to stall, let sit the ok for awhile, I will drop off again but what can I do ? The 240 does not have access to idle screw just L and H.. I did order tool but while under warranty I do not want to mess it up.. So what do you think the issue may be? I use Fresh Gas 91 , Husky oil mix and Husky bar oil. Gas id from Shell now a flt by night
Sorry for being long winded. Any manuals I should get ?
Thanks Richard
Issue first 5/6 tanks ran flawless. I run a tank then take a break, went to cut some more about 1 hr later, saw would not idle. throttle all ok no burps or farts. Drop off to my dealer, they adjusted idle. all good for 1 tank. then started to stall, let sit the ok for awhile, I will drop off again but what can I do ? The 240 does not have access to idle screw just L and H.. I did order tool but while under warranty I do not want to mess it up.. So what do you think the issue may be? I use Fresh Gas 91 , Husky oil mix and Husky bar oil. Gas id from Shell now a flt by night
Sorry for being long winded. Any manuals I should get ?
Thanks Richard