I’m rerouting my heater core lines. They are only 1/2” from the metal bulkhead. I’m going to cut these and might not have enough length remaining after I put on my 90s.
I need to find a 5/8” double flare tool, or the one that makes the heater core tubing bump profile for inlet and outlet tubes. All the kits I’ve seen max out at 1/2” for double flaring.
I might have to buy a heater core just to get the 5/8” fittings I need.
Any ideas? Thanks,
I need to find a 5/8” double flare tool, or the one that makes the heater core tubing bump profile for inlet and outlet tubes. All the kits I’ve seen max out at 1/2” for double flaring.
I might have to buy a heater core just to get the 5/8” fittings I need.
Any ideas? Thanks,